iPod-Hummer

DSC02004.JPG
How everything looked at the beginning and hopefully the end
DSC02006.JPG
The magic module, PA11-GM. Everything is just plug and go. No splicing, no rigging.
DSC02007.JPG
Everything comes out of the way easily. The whole front panel just snaps off. I put my thumb and forefinger in the lighter sockets and worked it out. Then there were four screws holding the radio in. All the controls are electronic.
DSC02008.JPG
I found the perfect spot for the module. From there it was easy to route the cable down to the glove box, where the iPod will be residing when in use.
DSC02009.JPG
Best to make sure everything works before closing everything up